Free · No obligation
Application Evaluation
Tell us what you need to lift, pull or position. An Allied engineer will recommend a standard Columbia unit, a modified one, or a custom design, and tell you what it takes to get there.
Reviewed by an engineer, not a sales queue
Partial information is fine; we’ll ask for the rest
Every unit run tested, with a manual and test report
What to have ready, and why it matters
| Item | What to give us | Why it matters |
|---|---|---|
| Load or line pull | Weight lifted or force pulled, and whether it’s at the hook or the drum | Sets the gearbox, brake and rope size |
| Line speed | Feet per minute, and on which layer | With load, sets the motor horsepower |
| Travel | How far the load moves, plus rope that stays on the drum | Sets drum size and fleet angle |
| Duty cycle | Cycles per hour, run time, starts and stops | Drives motor rating and brake heat |
| Power | Voltage, phase and frequency, or air or hydraulic supply | Decides the drive and controls |
| Environment | Indoor or outdoor, temperature, washdown, classified area | Sets enclosures, paint and certifications |
The application guidelines explain each of these in a one-page PDF.
Questions we get
Does an evaluation cost anything?
No. It’s how we quote, so there’s no charge and no obligation.
What if I don’t know some of the numbers?
Send what you have. An engineer will follow up for the rest, and often the application description is enough to start.
Can I send drawings or photos?
Yes. Reply to our first email with drawings, photos or a sketch of the rigging.
Is this only for custom units?
No. Most evaluations end in a standard Columbia model, sometimes with a different drum, ratio or controls.
Can a distributor submit for an end customer?
Yes. Put your company in “Company” and the end user’s location in “Where will it be installed.”